Using Rhynalox Sanding Sheets for Hand Sanding

Quick Answer

Rhynalox White Plus sanding sheets deliver smooth, clog-resistant results for hand sanding wood, finishes, and non-ferrous metals. Follow a simple step-by-step process to get the best finish and avoid common mistakes.

Step-by-Step Hand Sanding with Rhynalox Sheets

1. Prepare the surface: Clean the surface of dust, grease, or old finish. For bare wood, ensure it's dry and free of nails or staples that could tear the sheet. Always sand in the direction of the grain to avoid cross-grain scratches.
2. Cut or fold the sheet: Cut the 9x11 inch sheet into quarters or fold it into thirds for easier handling. A smaller piece gives better control and uses the abrasive more evenly. Folding creates a stiff edge that can help reach tight corners, but avoid folding over the abrasive side.
3. Choose the right grit: Start with a coarser grit (e.g., 80-100) for shaping or removing old finish, then move to finer grits (e.g., 150-220) for smoothing. Finish with 320 or higher for a polished surface. Skipping grits can leave visible scratches; progress gradually for a flawless finish.
4. Sand with light pressure: Hold the sheet flat and sand with light, even pressure. Let the abrasive do the work—pressing hard can cause deep scratches and premature wear. If the sheet loads up, tap it against a hard surface to dislodge dust, or switch to a fresh section.
5. Check your progress: Wipe the surface with a tack cloth or vacuum to inspect the finish. Look for smoothness and any remaining imperfections before moving to the next grit. A smooth, consistent surface means you're ready for the next step, whether that's staining or applying a topcoat.

Product Facts

• 9 X 11 Inch Rhynalox White Plus Sanding Sheets, 50 Pack: Premium aluminum oxide grain with a semi-open coat and resin-over-resin bonding. This construction provides a durable, sharp cutting surface that handles both softwoods and hardwoods without wearing out too quickly.

  

• 9 X 11 Inch Rhynalox White Plus Sanding Sheets, 50 Pack: Coated with a stearate to reduce loading. The stearate coating prevents the sheet from clogging with finish residue or sawdust, so you can keep sanding longer without switching sheets.